16-CH DIGITAL INPUTS, 8-CH DIGITAL OUTPUTS ETHERNET MODULE R-16DI-8DO

R-16DI-8DO is a mixed digital module with dual Ethernet ports 10/100 Mbps and programming Micro USB front port.

The instrument is designed for flexible wiring needs, reduced installation spaces, high density I / O applications with networking Integrated Ethernet.

R-16DI-8DO counts 16 PNP / NPN digital inputs also configurable as totalizers @ 32 bits and 8 digital relay outputs with maximum range 30 V / 1 A.

All totalizers are stored in non-volatile memory (FeRAM). The module is equipped with isolation between inputs, outputs and remaining low voltage circuits equal to 1.500 Vac. The configuration can take place via Seneca Studio software and web server with support HTML5. IP address and firmware version associated with the single module can be identified on a LAN via Seneca Studio.

R-16DI-8DO supports both ModBUS TCP-IP and serial communication RS485 with ModBUS RTU protocol.

Categories: Automation & IOT, Seneca | Automation Interface, I / O Modules

Description

Nr.16 PNP / NPN digital inputs configurable also as counters @ 32 bit max 5 KHz
Nr.8 Relay digital outputs max 30 V max 1 A
Nr.2 10/100 Mbps Ethernet ports, Nr.1 RS485 port, Nr.1 Micro USB port
Programming via Micro USB port or Ethernet web server and Seneca Studio
Multi-device connection in Ethernet daisy chain mode with Fault-bypass (active connection between the two
Ethernet ports in case of power failure)

Mirror I / O function (signal duplication) in Peer To Peer mode without the need for a MasterModBUS Pass Through function for Modbus Ethernet- Serial conversionIdeal for high I/O density applications with built-in Ethernet networking

Power supply : 10-40 Vdc; 19-28 VacAuxiliary voltage : output 12 Vdc / 40 mAMax power consumption : 3 WMax isolation : 1-5 kVacProtection degree : IP20Operating temperature : -20 to +65°CDimension (wxhxd) : 106 x 90 x 32 mmWeight : 170 g

Datasheet

No images found.

View Blog