Double Block and Bleed System

ASPL Double block and bleed is a special design to ensures that cross-stream contamination does not occur in multi-stream sample systems which are caused due to is leakages from switching valves and areas of unpurged tubing common to more than one stream.

As can be seen below diagram this design allows sample flow from the selected stream to pass through two valves enroot to the sample/calibration valve. The other streams are double blocked with two valves and leakages from valves at low pressure to escape out the bleed vent.

Hence here the purpose is now served by double block and bleeds valve, firstly it will prevent contamination in all the streams and remove the trap gas/ liquid by means of the given bleed vent/drain.

The solution can be provided for gases and liquid applications. In case of liquid contamination shall be connected to drain. Switching valves shall be provided Electric operated solenoid valve or air operated valve.

Multi-stream sample selection and calibration switching command shall be given by the analyzer unit/control unit. Sample fine filter and rotameters can be added to make it a complete sample system as per customer-specific requirements. This improves the reliability of the system where precise measurement is highly required.

Description

  • Avoid cross-stream contamination
  • Applicable or both gas-liquid
  • Equipped with both Rota meter and Filter
  • Used for critical process service
  • High availability
  • Reliable
  • Precise measurement
  • Option available with Valves
  • CCOE and ATEX approved certification
  • This can work within a harsh environment
Refer to the datasheet for detailed Information

Datasheet

No images found.