Place to Work

z-10-d-out 10-CH digital output module / RS485 MODbus rtu

 HomeAxis India  Products  Automation & IOT  Seneca | Automation Interface  I / O Modules  z-10-d-out 10-CH digital output module / RS485 MODbus rtu
11 Z 10 D OUT 1604930800

Z-10-D-OUT is used to drive N.10 MOSFETS from all of the control systems which are able to communicate with the transmission protocol MODBUS RTU through the RS485 serial interface. The digital output max load is 0,5 A (inductive) and 0,5 A (resistive) with maximum switch-on / switch-off cycle frequency of 2 cycles/ second. The module is ModBUS Slave and can be coupled with any ModBUS Master device. A 3-way galvanic isolation among Power supply // output // RS485 circuits assures the integrity of your datas.

Categories: , ,

Description

    It is possible to manage the output state if the interval time of RS485-bus communication failure is greater than a configurable time (up to 2000sec)

    Management of the output state if the interval time of a load short-circuited is greater than a configurable time (up to 8sec)

    It is possible to measure and control the outputs supply Vext. Configuration of the module (node) address and baud-rate by Dip-Switches. It is possible to add/remove the module to/from RS485-bus without disconnecting the communication or power supply.
    Power supply : 10-40 Vdc / 19-28 Vac / 50-60 Hz Power consumption : 1.5 W Isolation : 1.500 Vac (3 way) Protection Degree : IP20 Dimension :  (W x H x D) 17.5 x 100 x 112 mm Interface : 2 wire RS485 Speed : Up to 115.200 bps

    Datasheet

    No images found.

    View Blog